CLI Guide

defer-timer
Configure a timer that prevents unwanted flapping of downstream ports when the uplink port channel
goes down and comes up.
Syntax
defer-timerseconds
Defaults 10 (Standalone mode)
Parameters
seconds Specify the time (in seconds) to wait for the upstream port
channel (LAG 128) to come back up before server ports are
brought down. The range is from 1 to 120.
Command Modes UPLINK-STATE-GROUP
Supported Modes Standalone, Stacking, VLT
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage Information This command is not supported in Programmable-Mux mode.
description
Enter a text description of an uplink-state group.
Syntax
description text
Parameters
text Text description of the uplink-state group. The maximum
length is 80 alphanumeric characters.
Defaults none
Command Modes UPLINK-STATE-GROUP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Uplink Failure Detection (UFD)
1489