CLI Guide

ipv6–address Enter the destination IPv6 address for the tunnel.

Defaults none

Command Modes INTERFACE TUNNEL (conf-if-tu)

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.3(0.0) Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The tunnel interface is inoperable without a valid tunnel destination address for the

configured Tunnel mode.

To establish a logical tunnel to the particular destination address, use the

destination address of the outer tunnel header. If you configure a tunnel interface

or source address, the tunnel destination must be compatible.

tunnel flow-label

Configure the method to set the IPv6 flow label value in the outer tunnel header.

Syntax

tunnel flow-label value

To return to the default value of 0, use the no tunnel flow-label value

command.

Parameters

value Enter a value to set the IPv6 flow label value in the tunnel

header. The range is from 0 to 1048575. The default value is

Defaults 0 (Mapped original packet flow-label value to tunnel header flow-label value)