CLI Guide

Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
virtual-ip
Configure a virtual IP address for the active management interface. You can configure virtual addresses
both for IPv4 independently.
Syntax
virtual-ip {ipv4-address}
Parameters
ipv4-address Enter the IP address of the active management interface in a
dotted decimal format (A.B.C.D.).
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Each time you issue this command, it replaces the previously configured address of
the same family. The no virtual-ip command takes an address/prefix-length
argument, so that the desired address only is removed. If you enter the no
virtual-ip
command without any specified address, the IPv4 virtual addresses
are removed.
Example
Dell#virtual-ip 10.11.197.99/16
write
Copy the current configuration to either the startup-configuration file or the terminal.
Syntax
write {memory | terminal}
Parameters
memory
Enter the keyword memory to copy the current running
configuration to the startup configuration file. This
Control and Monitoring
147