CLI Guide

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information You also must configure an authentication key for NTP traffic using the ntp
authentication-key command.
Related
Commands
ntp authentication-key — configures the authentication key for NTP traffic.
ntp trusted-key — configures a key to authenticate.
ntp authentication-key
Specify a key for authenticating the NTP server.
Syntax
ntp authentication-key number md5 [0 | 7] key
Parameters
number Specify a number for the authentication key. The range is
from 1 to 4294967295.
This number must be the same as the number parameter
configured in the ntp trusted-key command.
md5 Specify that the authentication key is encrypted using MD5
encryption algorithm.
0 Specify that authentication key is entered in an unencrypted
format (default).
7 Specify that the authentication key is entered in DES
encrypted format.
key Enter the authentication key in the previously specified
format.
Defaults NTP authentication is not configured by default. If you do not specify the option [0
| 7], 0 is selected by default.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
System Time
1459