CLI Guide

Defaults Not configured.
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
You can change the order of the month and day parameters to enter the time and
date as time day month year . You cannot delete the software clock.
The software clock runs only when the software is up. The clock restarts, based on
the hardware clock, when the switch reboots.
Dell Networking recommends using an outside time source, such as NTP, to
ensure accurate time on the switch.
Example
Dell#clock set 12:11:00 21 may 2012
Dell#
clock summer-time date
Set a date (and time zone) on which to convert the switch to daylight saving time on a one-time basis.
Syntax
clock summer-time time-zone date start-month start-day start-
year start-time end-month end-day end-year end-time [offset]
To delete a daylight saving time zone configuration, use the no clock summer-
time command.
Parameters
time-zone Enter the three-letter name for the time zone. This name is
displayed in the show clock output.
start-month Enter the name of one of the 12 months in English. You can
enter the name of a day to change the order of the display
to time day month year.
start-day Enter the number of the day. The range is from 1 to 31. You
can enter the name of a month to change the order of the
display to time day month year.
start-year Enter a four-digit number as the year. The range is from
1993 to 2035.
1454
System Time