CLI Guide

max-age
To maintain configuration information before refreshing that information, set the time interval for the
spanning tree bridge.
Syntax
max-age seconds
To return to the default values, use the no max-age command.
Parameters
seconds Enter a number of seconds the system waits before
refreshing configuration information. The range is from 6 to
40. The default is 20 seconds.
Defaults 20 seconds
Command Modes SPANNING TREE
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
forward-delay — changes the wait time before STP transitions to the Forwarding
state.
hello-time — changes the time interval between BPDUs.
portfast bpdufilter default
Enable BPDU Filter globally to filter transmission of BPDU on port fast enabled interfaces.
Syntax
portfast bpdufilter default
To disable global bpdu filter default, use the no edge-port bpdufilter
default command.
Defaults Disabled
Command Modes SPANNING TREE
Command History
Version Description
9.9(0.0) Introduced on the FN MXL.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
1446
Spanning Tree Protocol (STP)