CLI Guide

To disable storm control for unknown-unicast traffic, use the no storm-control
unknown-unicast [packets_per_second in] command.
Parameters
packets_per_seco
nd
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces.
storm-control unknown-unicast (Interface)
Configure percentage of unknown-unicast traffic allowed on the interface.
Syntax
storm-control unknown-unicast [packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-
control unknown-unicast [packets_per_second in] command.
Parameters
packets_per_seco
nd
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554431.
Command Modes INTERFACE (conf-if-interface-slot/port)
Supported Modes Programmable-Mux (PMUX)
Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
Storm Control
1441