CLI Guide

1–14 This preference parameter allows you to specify the
management priority of one backup switch over another,
with 0 the lowest priority and 14 the highest. The switch
with the highest priority value is chosen to become the
management unit if the active management unit fails or on
the next reload.
Defaults 0
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6.(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage Information This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Related
Commands
• reload – reboots Dell Networking Operating System (OS).
• show system – displays the status of all stack members or a specific member.
stack-unit provision
Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is
executed on the management unit.
Syntax
stack-unit 0–5] provision {MXL-10/40GbE}
Parameters
0–5 Enter a stack member identifier, from 0 to 5, of the switch
that you want to add to the stack.
MXL-10/40GbE Enter the model identifier of the switch to be added as a
stack member. This identifier is also referred to as the
provision type.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Stacking Commands
1431