CLI Guide

Related
Commands
power-cycle stack-unit—resets the designated stack member.
show diag— displays the data plane or management plane input and output
statistics of the designated component of the designated stack member.
show system—displays the current status of all stack members or a specific
member.
show system stack-unit iom-mode
Displays the current iom-mode (stack/standalone) and the mode configured after next reboot.
Syntax
show system stack-unit unit-number iom-mode
Parameters
unit number <0–
5>
Enter the number of the member stack unit. The range is
from 0 to 5.
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6.(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage information This command is supported on the M I/O, FN410S, and FN410T Aggregators
Example
Dell#show system stack-unit all iom-mode ?
| Pipe through a command
<cr>
Dell#show system stack-unit all iom-mode
Unit Boot-Mode Next-Boot
------------------------------------------------
0 stack stack
1 stack stack
2 stack stack
3 stack stack
4 Not Present
5 Not Present
Dell#
1428
Stacking Commands