CLI Guide

logging on
Specify that debug or error messages are asynchronously logged to multiple destinations, such as the
logging buffer, Syslog server, or terminal lines.
Syntax
logging on
To disable logging to logging buffer, Syslog server and terminal lines, use the no
logging on command.
Defaults Enabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you use the no logging on command, messages are logged only to the
console.
Related
Commands
logging — enables logging to the Syslog server.
logging buffered — sets the logging buffered parameters.
logging console — sets the logging console parameters.
logging monitor — sets the logging parameters for the terminal connections.
logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog
server.
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging
source-interface command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keywords port-
channel
then a number. Tthe range is from 1 to 128.
Simple Network Management Protocol (SNMP) and Syslog
1415