CLI Guide

logging history
Specify which messages are logged to the history table of the switch and the SNMP network
management station (if configured).
Syntax
logging history level
To return to the default values, use the no logging history command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following
equivalent words: emergencies, alerts, critical,
errors, warnings, notifications, informational, or
debugging. The default is 4 or warnings.
Defaults warnings or 4
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you configure the snmp-server trap-source command, the system
messages logged to the history table are also sent to the SNMP network
management station.
Related
Commands
show logging — displays information logged to the history buffer.
logging history size
Specify the number of messages stored in the system logging history table.
Syntax
logging history size size
To return to the default values, use the no logging history size command.
Parameters
size Indicate a value as the number of messages to be stored.
The range is from 0 to 500. The default is 1 message.
Defaults 1 message
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Simple Network Management Protocol (SNMP) and Syslog
1413