CLI Guide

Example
Dell#conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related
Commands
show snmp group — displays the group name, security model, view status, and
storage type of each group.
show running-config — displays the SNMP running configuration.
snmp-server host
Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address [traps | informs] [version 1 | 2c |
3] [auth | no auth | priv] [community-string] [udp-port port-
number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address
[traps | informs] [version 1 | 2c | 3] [auth | noauth | priv]
[community-string] [udp-port number] [notification-type]
command.
Parameters
ip-address Enter the keyword host then the IP address of the host
(configurable hosts is limited to 16).
traps (OPTIONAL) Enter the keyword traps to send trap
notifications to the specified host. The default is traps.
informs (OPTIONAL) Enter the keyword informs to send inform
notifications to the specified host. The default is traps.
version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the
security model then the security model version number 1,
2c, or 3:
• Version 1 is the least secure version.
• Version 3 is the most secure of the security modes.
• Version 2c allows transmission of informs and counter
64, which allows for integers twice the width of what is
normally allowed.
The default is version 1.
auth (OPTIONAL) Enter the keyword auth to specify
authentication of a packet without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no
authentication of a packet.
1396
Simple Network Management Protocol (SNMP) and Syslog