CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.8(0.0) Added the following two SNMP notification options:
syslog-reachable and syslog-unreachable.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The system supports up to 16 SNMP trap receivers.
If you do not configure this command, no traps controlled by this command are
sent. If you do not specify a notification-type and notification-option,
all traps are enabled.
Related
Commands
snmp-server community — enables SNMP and sets the community string.
snmp-server engineID
Configure the name for both the local and remote SNMP engines on the router.
Syntax
snmp-server engineID [local engineID] [remote ip-address udp-
port port-number engineID]
To return to the default, use the no snmp-server engineID [local
engineID] [remote ip-address udp-port port-number engineID]
command.
Parameters
local engineID
Enter the keyword local then the engine ID number that
identifies the copy of the SNMP on the local device.
Format (as specified in RFC 3411): 12 octets.
• The first four octets are set to the private enterprise
number.
• The remaining eight octets are the MAC address of the
chassis.
remote ip-address Enter the keyword remote then the IP address that
identifies the copy of the SNMP on the remote device.
udp-port port-
number engineID
Enter the keywords udp-port then the user datagram
protocol (UDP) port number on the remote device. The
range is from 0 to 65535. The default is 162.
Defaults As above.
Command Modes CONFIGURATION
Simple Network Management Protocol (SNMP) and Syslog
1393