CLI Guide

snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-
option]
To disable traps, use the no snmp-server enable traps [notification-
type] [notification-option] command.
Parameters
notification-type Enter the type of notification from the following list:
• ecfm — Notification of changes to ECFM.
• entity — Notification of changes to entity.
• envmon — For Dell Networking device notifications
when an environmental threshold is exceeded.
• eoam — Notification of changes to the EOAM state.
• ets — Notification of changes to the ets traps.
• fips — Notification of changes to the FIP snooping
state.
• lacp — Notification of changes.
• pfc — Notification of changes to pfc traps.
• snmp — Notification of RFC 1157 traps.
• stp — Notification of a state change in the spanning
tree protocol (RFC 1493).
• vrrp — Notification of a state change in a VRRP group.
• xstp — Notification of a state change in MSTP (802.1s),
RSTP (802.1w), and PVST+.
notification-
option
For the envmon notification-type, enter one of the following
optional parameters:
• temperature
For the snmp notification-type, enter one of the following
optional parameters:
• authentication
• coldstart
• linkdown
• linkup
• syslog-reachable
• syslog-unreachable
Defaults Not enabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
1392
Simple Network Management Protocol (SNMP) and Syslog