CLI Guide

NOTE: After a physical port is a member of a LAG, it inherits the sFlow
configuration from the LAG port.
Related
Commands
sflow enable (Global) — turns sFlow globally.
sflow extended-switch enable
Enable packing information on a switch only.
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable]
command.
Parameters
enable Enter the keyword enable to enable global extended
information.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The Dell Networking OS version 7.8.1.0 and later enhances the sflow
implementation for real time traffic analysis to provide extended gateway
information in cases where the destination IP addresses are learned by different
routing protocols and for cases where the destination is reachable over ECMP.
Related
Commands
show sflow — displays the sFlow configuration.
sflow max-header-size extended
Set the maximum header size of a packet to 256 bytes.
Syntax
sflow max-header-size extended
To reset the maximum header size of a packet, use the[no] sflow max-
header-size extended command.
1374
sFlow