CLI Guide

RADIUS Commands
The following RADIUS commands are supported by Dell Networking Operating System (OS).
debug radius
View RADIUS transactions to assist with troubleshooting.
Syntax
debug radius
To disable debugging of RADIUS, use the no debug radius command.
Defaults Disabled.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip radius source-interface
Specify an interface’s IP address as the source IP address for RADIUS connections.
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
1336
Security