CLI Guide

edge-port bpdufilter default
To filter transmission of BPDU on port fast enabled interfaces, enable BPDU Filter globally.
Syntax
edge-port bpdufilter default
To disable global bpdu filter default, use the no edge-port bpdufilter
default command.
Parameters
priority-value Enter a number as the bridge priority value in increments of
4096. The range is from 0 to 61440. The default is 32768.
Defaults Disabled
Command Modes CONFIGURATION (conf-rstp)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
protocol spanning-tree rstp
To configure RSTP, enter RSTP mode.
Syntax
protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not configured
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the
system, use the no disable command from RSTP mode.
Example
Dell(conf)#protocol spanning-tree rstp
Dell(config-rstp)##no disable
1300
Rapid Spanning Tree Protocol (RSTP)