CLI Guide

Parameters
controlEntry
integer
Enter the keyword controlEntry to specify the RMON
group of statistics using a value. Then enter an integer value
from 1 to 65535 that identifies the RMON Statistic Table. The
integer value must be a unique in the RMON statistic table.
owner name (OPTIONAL) Enter the keyword owner then the owner
name to record the owner of the RMON group of statistics.
Defaults none
Command Modes CONFIGURATION INTERFACE (config-if)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
rmon event
Add an event in the RMON event table.
Syntax
rmon event number [log] [trap community] [description string]
[owner name]
To disable RMON on an interface, use the no rmon event number command.
Parameters
number Assign an event number in integer format from 1 to 65535.
The number value must be unique in the RMON event table.
log (OPTIONAL) Enter the keyword log to generate an RMON
log entry. The log entry is triggered and sets the eventType
in the RMON MIB to log or log-and-trap. The default is No
log.
trap community (OPTIONAL) Enter the keyword trap then an SNMP
community string to configure the eventType setting in the
RMON MIB. This keyword sets either snmp-trap or log-and-
trap. The default is public.
description string (OPTIONAL) Enter the keyword description then a string
describing the event.
owner name (OPTIONAL) Enter the keyword owner then the name of the
owner of this event.
Defaults As noted in the Parameters section.
Remote Monitoring (RMON)
1285