CLI Guide

rmon collection history
Enable the RMON MIB history group of statistics collection on an interface.
Syntax
rmon collection history {controlEntry integer} [owner name]
[buckets number] [interval seconds]
To remove a specified RMON history group of statistics collection, use the no
rmon collection history {controlEntry integer} command.
Parameters
controlEntry
integer
Enter the keyword controlEntry to specify the RMON
group of statistics using a value. Then enter an integer value
from 1 to 65535 that identifies the RMON group of statistics.
The integer value must be a unique index in the RMON
history table.
owner name (OPTIONAL) Enter the keyword owner then the owner
name to record the owner of the RMON group of statistics.
buckets number (OPTIONAL) Enter the keyword buckets then the number
of buckets for the RMON collection history group of
statistics. The bucket range is from 1 to 1000. The default is
50.
interval seconds (OPTIONAL) Enter the keyword interval then the number
of seconds in each polling cycle. The range is from 5 to
3600 seconds. The default is 1800 seconds.
Defaults none
Command Modes CONFIGURATION INTERFACE (config-if)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
rmon collection statistics
Enable RMON MIB statistics collection on an interface.
Syntax
rmon collection statistics {controlEntry integer} [owner name]
To remove RMON MIB statistics collection on an interface, use the no rmon
collection statistics {controlEntry integer} command.
1284
Remote Monitoring (RMON)