CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When the offset metric is applied to an interface, that value takes precedence over
an offset value that is not extended to an interface.
Related
Commands
ip prefix-list — enters PREFIX-LIST mode and configure a prefix list.
output-delay
Set the interpacket delay of successive packets to the same neighbor.
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, use the no
output-delay command.
Parameters
delay Specify a number of milliseconds as the delay interval. The
range is from 8 to 50.
Defaults Not configured.
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is intended for low-speed interfaces.
passive-interface
Suppress routing updates on a specified interface.
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface
command.
1274
Routing Information Protocol (RIP)