CLI Guide

Defaults No RIP network is configured.
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address the network command
specifies.
offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the no offset-list prefix-list-name {in |
out} offset [interface] command.
Parameters
prefix-list-name Enter the name of an established Prefix list to determine
which incoming routes are modified.
offset Enter a number from zero (0) to 16 to be applied to the
incoming route metric matching the access list specified. If
you set an offset value to zero (0), no action is taken.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER RIP
Supported Modes Full–Switch
Routing Information Protocol (RIP)
1273