CLI Guide

To return to the default values, use the no distance weight [ip-address
mask] command.
Parameters
weight Enter a number from 1 to 255 for the weight (for
prioritization). The default is 120.
ip-address (OPTIONAL) Enter the IP address, in dotted decimal format
(A.B.C.D), of the host or network to receive the new
distance metric.
mask If you enter an IP address, also enter a mask for that IP
address, in either dotted decimal format or /prefix format
(/x).
prefix-name (OPTIONAL) Enter a configured prefix list name.
Defaults weight = 120
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
default-metric — assigns one distance metric to all routes learned using the
redistribute command.
distribute-list in
Configure a filter for incoming routing updates.
Syntax
distribute-list prefix-list-name in [interface]
To delete the filter, use the no distribute-list prefix-list-name in
command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface (OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Routing Information Protocol (RIP)
1267