CLI Guide

48
Routing Information Protocol (RIP)
Routing information protocol (RIP) is a distance vector routing protocol. The Dell Networking Operating
System (OS) supports both RIP version 1 (RIPv1) and RIP version 2 (RIPv2).
The implementation of RIP is based on IETF RFCs 2453 and RFC 1058. For more information about
configuring RIP, refer to the Dell Networking OS Configuration Guide.
auto-summary
Restore the default behavior of automatic summarization of subnet routes into network routes. This
command applies only to RIP version 2.
Syntax
auto-summary
To send sub-prefix routing information, use the no auto-summary command.
Defaults Enabled.
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
clear ip rip
Update all the RIP routes in the routing table.
Syntax
clear ip rip
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
Routing Information Protocol (RIP)
1263