CLI Guide

To remove an existing output QoS policy, use the no qos-policy-output qos-
policy-name command.
Parameters
qos-policy-name Enter your output QoS policy name in character format (32
characters maximum).
Defaults none
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To specify the name of the output QoS policy, use this command. After the output
policy is specified, rate-limit, bandwidth-percentage, and WRED can be defined.
This command enables Qos-Policy-Output Configuration mode — (conf-qos-
policy-out).
Related
Commands
bandwidth-percentage — assigns weight to the class/queue percentage.
rate police
Police the incoming traffic rate on the selected interface.
Syntax
rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of
64. The range is from 0 to 40000000. The default
granularity is Megabits per second (Mbps).
committed-rate Enter the bandwidth in Mbps. The range is from 0 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is 100.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to
specify the peak rate in Mbps. The range is from 0 to 10000.
The default is the same as designated for committed-rate.
Quality of Service (QoS)
1239