CLI Guide

policy-aggregate — allows an aggregate method of configuring per-port QoS
using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-input
Create a QoS input policy on the router.
Syntax
qos-policy-input qos-policy-name [layer2]
To remove an existing input QoS policy from the router, use the no qos-policy-
input qos-policy-name [layer2] command.
Parameters
qos-policy-name Enter the name for the policy map in character format (32
characters maximum).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2
Class Map. The default is Layer 3.
Defaults Layer 3
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To specify the name of the input QoS policy, use this command. After the input
policy is specified, rate-police is defined. This command enables Qos-Policy-Input
Configuration mode — (conf-qos-policy-in).
When changing a Service-Queue configuration in a QoS policy map, all QoS rules
are deleted and re-added automatically to ensure that the order of the rules is
maintained. As a result, the Matched Packets value shown in the show qos
statistics
command is reset.
Related
Commands
rate police — incoming traffic policing function.
qos-policy-output
Create a QoS output policy.
Syntax
qos-policy-output qos-policy-name
1238
Quality of Service (QoS)