CLI Guide

show ip pim tib
View the PIM tree information base (TIB).
Syntax
show ip pim tib [group-address [source-address]]
Parameters
group-address (OPTIONAL) Enter the group address in dotted decimal
format (A.B.C.D).
source-address (OPTIONAL) Enter the source address in dotted decimal
format (A.B.C.D).
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip pim tib command shown in the following
example.
Field Description
(S, G) Displays the entry in the multicast PIM database.
uptime Displays the amount of time the entry has been in the PIM
route table.
expires Displays the amount of time until the entry expires and is
removed from the database.
RP Displays the IP address of the RP/source for this entry.
flags List the flags to define the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = Dell Networking OS is registering this entry for a
multicast source
• T = packets were received via Shortest Tree Path
• J = first packet from the last hop router is received and
the entry is ready to switch to SPT
• K = acknowledge pending state
PIM-Sparse Mode (PIM-SM)
1173