CLI Guide

Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is applied to the subsequent PIM-BSR. Existing BSR advertisements
are cleaned up by time-out. To clean the candidate RP advertisements, use the
clear ip pim rp-mapping command.
ip pim bsr-candidate
To join the Bootstrap election process, configure the PIM router.
Syntax
ip pim bsr-candidate interface [hash-mask-length] [priority]
To return to the default value, use the no ip pim bsr-candidate command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
hash-mask-length (OPTIONAL) Enter the hash mask length. The range is from
zero (0) to 32. The default is 30.
priority (OPTIONAL) Enter the priority used in Bootstrap election
process. The range is from zero (0) to 255. The default is
zero (0).
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
PIM-Sparse Mode (PIM-SM)
1155