CLI Guide

Parameters
number
Enter the number as the priority. The range is from 1 to 255.
Defaults 1
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Setting a priority of 0 makes the router ineligible for election as a Designated
Router or Backup Designated Router.
Use this command for interfaces connected to multi-access networks, not point-
to-point networks.
ipv6 router ospf
Enable OSPF for IPv6 router configuration.
Syntax
ipv6 router ospf process-id
To exit OSPF for IPv6, use the no ipv6 router ospf process-id command.
Parameters
process-id
Enter the process identification number. The range is from 1
to 65535.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
1132
Open Shortest Path First (OSPFv2 and OSPFv3)