CLI Guide

Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
In general, the path cost is calculated as:
10^8 / bandwidth
Using this formula, the default path cost is calculated as:
• TenGigabitEthernet—Default cost is 1
• Ethernet—Default cost is 10
ipv6 ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the time interval elapses,
the neighboring routers declare the router down.
Syntax
ipv6 ospf dead-interval seconds
Parameters
seconds
Enter the time interval in seconds. The range is from 1 to
65535 seconds.
Defaults 40 seconds (Ethernet).
Command Modes INTERFACE
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
By default, the dead interval is four times longer than the default ipv6 ospf
hello-interval command.
1128
Open Shortest Path First (OSPFv2 and OSPFv3)