CLI Guide

multiplier value Enter the keyword multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• active — The active system initiates the BFD session.
Both systems can be active for the same session.
• passive — The passive system does not initiate a session.
It only responds to a request for session initialization
from the active system.
The default is Active.
Defaults See Parameters.
Command Modes INTERFACE
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command provides the flexibility to fine-tune the timer values based on
individual interface needs when you configure the ipv6 ospf bfd command in
CONFIGURATION mode. Any timer values specified with this command overrides
timers set using the bfd all-neighbors command. Using the no form of this
command does not disable BFD if you configured BFD in CONFIGURATION mode.
To disable BFD on a specific interface while BFD is configured in CONFIGURATION
mode, use the keyword disable.
ipv6 ospf cost
Explicitly specify the cost of sending a packet on an interface.
Syntax
ipv6 ospf interface-cost
Parameters
interface-cost
Enter a unsigned integer value expressed as the link-state
metric. The range is from 1 to 65535.
Defaults Default cost based on the bandwidth.
Command Modes INTERFACE
Open Shortest Path First (OSPFv2 and OSPFv3)
1127