CLI Guide

For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits
(non-encrypted) or 80 hex digits (encrypted).
Defaults Not configured.
Command Modes INTERFACE
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Before you enable IPsec authentication on an OSPFv3 interface, first enable IPv6
unicast routing globally, configure an IPv6 address and enable OSPFv3 on the
interface, and assign the interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or
encryption) on the router. Configure the same authentication policy (same SPI and
key) on each OSPFv3 interface in a link.
ipv6 ospf bfd all-neighbors
Establish BFD sessions with all OSPFv3 neighbors on a single interface or use non-default BFD session
parameters.
Syntax
ipv6 ospf bfd all-neighbors [disable | [interval interval
min_rx min_rx multiplier value role {active | passive}]]
To disable all BFD sessions on an OSPFv3 interface implicitly, use the no ipv6
ospf bfd all-neighbors disable command.
Parameters
disable (OPTIONAL) Enter the keyword disable to disable BFD on
this interface.
interval
milliseconds
(OPTIONAL) Enter the keyword interval to specify non-
default BFD session parameters beginning with the
transmission interval. The range is from 50 to 1000. The
default is 100.
min_rx
milliseconds
Enter the keywords min_rx to specify the minimum rate at
which the local system would like to receive control packets
from the remote system. The range is from 50 to 100. The
default is 100.
1126
Open Shortest Path First (OSPFv2 and OSPFv3)