CLI Guide

Defaults none.

Command Modes ROUTER OSPF

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

This command is either enabled or disabled. If no OSPF process is identified as the

MIB manager, the first OSPF process is used.

If an OSPF process has been selected, it must be disabled prior to assigning new

process ID the MIB responsibility.

network area

Define which interfaces run OSPF and the OSPF area for those interfaces.

Syntax

network ip-address mask area area-id

To disable an OSPF area, use the no network ip-address mask area area-

id command.

Parameters

ip-address Specify a primary or secondary address in dotted decimal

format. The primary address is required before adding the

secondary address.

mask Enter a network mask in /prefix format. (/x)

area-id Enter the OSPF area ID as either a decimal value or in a valid

IP address. Decimal value range is from 0 to 65535. IP

address format is dotted decimal format A.B.C.D.

NOTE: If the area ID is smaller than 65535, it is

converted to a decimal value. For example, if you use an

area ID of 0.0.0.1, it is converted to 1.