CLI Guide

distribute-list in
Apply a filter to incoming routing updates from OSPF to the routing table.
Syntax
distribute-list prefix-list-name in [interface]
To delete a filter, use the no distribute-list prefix-list-name in
[interface] command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface (OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For Port Channel groups, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER OSPF
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
distribute-list out
To restrict certain routes destined for the local routing table after the SPF calculation, apply a filter.
Syntax
distribute-list prefix-list-name out [bgp | connected | isis |
rip | static]
To remove a filter, use the no distribute-list prefix-list-name out
[bgp | connected | isis | rip | static] command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
bgp (OPTIONAL) Enter the keyword bgp to specify that BGP
routes are distributed.
connected (OPTIONAL) Enter the keyword connected to specify that
connected routes are distributed.
1064
Open Shortest Path First (OSPFv2 and OSPFv3)