CLI Guide

Parameters
seconds Enter the time period (in seconds) used to send FIP
keepalive messages to peer devices. The range is from 8 to
90 seconds.
Defaults 8 seconds
Command Modes FCoE MAP
Supported Modes All Modes
Command History
Version Description
9.6(0.0) Supported on the FN 2210S Aggregator.
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Usage Information
To delete the FIP keepalive time period from an FCoE map, enter the no fka-
adv-erpiod command.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in
FCoE maps.
keepalive
In an FCoE map, enable the monitoring of FIP keepalive messages (if it is disabled).
Syntax
keepalive
Parameters None
Defaults FIP keepalive monitoring is enabled on Ethernet and Fibre Channel interfaces.
Command Modes FCoE MAP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Supported on the FN 2210S Aggregator.
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
NPIV Proxy Gateway
1043