CLI Guide

To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map
command.
Use the dcb-map command to create a DCB map to specify PFC and ETS settings
and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC
and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is
enabled on Ethernet ports by default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name
command in Interface configuration mode.
Related
Commands
show qos dcb-map– displays the dcb-map profiles configured on the system.
dcb-map stack-unit all stack-ports all– applies a DCB map on all ports of a switch
stack.
description (for FCoE maps)
In an FCoE map, add a text description of the FCoE and FC parameters used to transmit storage traffic
over an FN 2210S Aggregator and M I/O Aggregator NPIV proxy gateway in a converged fabric.
Syntax
description text
Parameters
text Enter a maximum of 32 characters.
Defaults None
Command Modes FCOE MAP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Supported on the FN 2210S Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage Information
The text description is displayed in show fcoe-map command output.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
NPIV Proxy Gateway
1037