CLI Guide

debug ipv6 mld_host
Enable the collection of debug information for MLD host transactions.
Syntax
[no] debug ipv6 mld_host [int-count | interface type] [slot/
port-range]
To discontinue collection of debug information for the MLD host transactions, use
the no debug ipv6 mld_host command.
Parameters
int-count Enter the keyword count to indicate the number of
required debug messages.
interface type Enter the following keywords and slot/port information:
• For a 10G Ethernet interface, enter the keyword
tengigabitethernet then the slot/port information.
• For a management interface, enter the keyword
managementinterface then the slot/port information.
• For a port-channel interface, enter the keywords port-
channel then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
slot/port information.
Default Disabled
Command Modes EXEC
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2.(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To debug the MLD protocol for all ports or for specified ports, use the debug
ipv6 mld_host command. Displayed information includes when a query is
received, when a report is sent, when a mcast joins or leaves a group, and some
reasons why an MLD query is rejected.
ip multicast-limit
To limit the number of multicast entries on the system, use this feature.
Syntax
ip multicast-limit limit
Parameters
limit Enter the desired maximum number of multicast entries on
the system. The range is from 1 to 50000.
1030
Multicast