CLI Guide

Multicast

The multicast commands are supported by Dell Networking Operating System (OS).

This chapter contains the following sections:

• IPv4 Multicast Commands

• IPv6 Multicast Commands

IPv4 Multicast Commands

The following section contains the IPv4 multicast commands.

clear ip mroute

Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent

multicast (PIM) tree information base, use the

clear ip pim tib command.

Syntax

clear ip mroute {group-address [source-address] | * | snooping}

Parameters

group-address

[source-address]

Enter the multicast group address and source address (if

desired), in dotted decimal format, to clear information on a

specific group.

* Enter * to clear all multicast routes.

snooping Enter the keyword snooping to delete multicast snooping

route table entries.

Command Modes EXEC Privilege

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.2.(0.0) Introduced on the MXL 10/40GbE Switch IO Module.

Commands

show ip pim tib — shows the PIM tree information base.

Multicast

1023