Administrator Guide

NOTE: If all of the following conditions are true, the Portmode Hybrid conguration is not applied, because of the conguration
process for server ports as switch ports by default:
• The running conguration is saved in ash.
• The startup conguration is deleted.
• The switch is reloaded.
• The saved conguration is copied to the running conguration.
To avoid this scenario, delete the switch port conguration from the running conguration before copying the saved conguration to
the running conguration.
Example of Copying a File to an FTP Server
The bold ash shows the local location and the bold ftp shows the remote location.
Dell#copy flash://FTOS-EF-8.2.1.0.bin ftp://myusername:mypassword@10.10.10.10/
/FTOS/FTOS-EF-8.2.1.0
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
27952672 bytes successfully copied
Example of Importing a File to the Local System
core1#$//copy ftp://myusername:mypassword@10.10.10.10//FTOS/
FTOS-EF-8.2.1.0.bin flash://
Destination file name [FTOS-EF-8.2.1.0.bin.bin]:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
26292881 bytes successfully copied
Save the Running-Conguration
The running-conguration contains the current system conguration. Dell Networking recommends coping your running-conguration to
the startup-conguration.
The system uses the startup-conguration during boot-up to congure the system. The startup-conguration is stored in the internal ash
on the IOM by default, but you can save it to a USB ash device or a remote server.
The commands in this section follow the same format as those commands in the Copy Files to and from the System section but use the
lenames startup-cong and running-cong. These commands assume that current directory is the internal ash, which is the system
default.
• Save the running-cong to the startup-conguration on the internal ash.
EXEC Privilege mode
copy running-config startup-config
• Save the running-conguration on the IOM.
EXEC Privilege mode
copy running-config usbflash://filename
• Save the running-conguration to an FTP server.
EXEC Privilege mode
copy running-config ftp:// username:password@{hostip | hostname}/filepath/ filename
• Save the running-conguration to a TFTP server.
EXEC Privilege mode
copy running-config tftp://{hostip | hostname}/ filepath/filename
• Save the running-conguration to an SCP server.
EXEC Privilege mode
copy running-config scp://{hostip | hostname}/ filepath/filename
Getting Started
55