Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsFN IO Module
391392393394395396397398399400
ICMP
For diagnostics, the internet control message protocol (ICMP) provides routing information to end stations by choosing the best route
(ICMP redirect messages) or determining if a router is reachable (ICMP Echo or Echo Reply).
ICMP error messages inform the router of problems in a particular packet. These messages are sent only on unicast trac.
Conguration Tasks for ICMP
The following lists the conguration tasks for ICMP.
• Enabling ICMP Unreachable Messages
For a complete listing of all commands related to ICMP, refer to the Dell Networking OS Command Line Reference Guide.
Enabling ICMP Unreachable Messages
By default, ICMP unreachable messages are disabled.
When enabled, ICMP unreachable messages are created and sent out all interfaces.
To disable and re-enable ICMP unreachable messages, use the following commands.
• Set the system to create and send ICMP unreachable messages on the interface.
INTERFACE mode
ip unreachable
To view if ICMP unreachable messages are sent on the interface, use the show config command in INTERFACE mode. If it is not listed
in the show config command output, it is enabled. Only non-default information is displayed in the show config command output.
UDP Helper
User datagram protocol (UDP) helper allows you to direct the forwarding IP/UDP broadcast trac by creating special broadcast addresses
and rewriting the destination IP address of packets to match those addresses.
Congure UDP Helper
Conguring the system to direct UDP broadcast is a one-step process:
1 Enable UDP helper and specify the UDP ports for which trac is forwarded. Refer to Enabling UDP Helper.
Important Points to Remember
• The existing ip directed broadcast command is rendered meaningless if you enable UDP helper on the same interface.
• The broadcast trac rate should not exceed 200 packets per second when you enable UDP helper.
• You may specify a maximum of 16 UDP ports.
• UDP helper is compatible with IP helper (ip helper-address):
• UDP broadcast trac with port number 67 or 68 are unicast to the dynamic host conguration protocol (DHCP) server per the ip
helper-address conguration whether or not the UDP port list contains those ports.
• If the UDP port list contains ports 67 or 68, UDP broadcast trac is forwarded on those ports.
396
IPv4 Routing