Administrator Guide

View Advanced Interface Information
The following options have been implemented for the show [ip | running-config] interfaces commands.
When you use the configured keyword, only interfaces that have non-default congurations display.
Example of show Commands that Use the configured Keyword
Example of the show interfaces switchport Command
The following example lists the possible show commands that have the congured keyword available:
Dell#show interfaces configured
Dell#show interfaces tengigabitEthernet 0 configured
Dell#show ip interface configured
Dell#show ip interface tengigabitEthernet 1 configured
Dell#show interfaces fortygigabitEthernet 0 configured
Dell#show ip interface fortygigabitEthernet 1 configured
Dell#show ip interface brief configured
Dell#show running-config interfaces configured
Dell#show running-config interface tengigabitEthernet 1 configured
In EXEC mode, the show interfaces switchport command displays only interfaces in Layer 2 mode and their relevant
conguration information. The show interfaces switchport command displays the interface, whether it supports IEEE 802.1Q
tagging or not, and the VLANs to which the interface belongs.
Dell#show interfaces switchport
Name: TenGigabitEthernet 13/0
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/1
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/2
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/3
802.1QTagged: True
Vlan membership:
Vlan 2
--More--
Conguring the Interface Sampling Size
You can enter any value between ve and 299 seconds (the default). If you enter 1 to 5 seconds, software polling is done at 5 second
intervals. If you enter 6 to 10 seconds, software polling is done at 10 second interval. For any other value, software polling is done once
every 15 seconds. So, for example, if you enter “19”, you actually get a sample of the past 15 seconds.
All LAG members inherit the rate interval conguration from the LAG.
The following example shows how to congure rate interval when changing the default value.
To congure the number of seconds of trac statistics to display in the show interfaces output, use the following command.
• Congure the number of seconds of trac statistics to display in the show interfaces output.
INTERFACE mode
rate-interval
378
Interfaces