Administrator Guide

Conguring FIP Snooping
You can enable FIP snooping globally on all FCoE VLANs on a switch or on an individual FCoE VLAN.
By default, FIP snooping is disabled.
To enable FCoE transit on the switch and congure the FCoE transit parameters on ports, follow these steps.
1 Enable the FCoE transit feature on a switch.
CONFIGURATION mode.
feature fip-snooping
2 Enable FIP snooping on all VLANs or on a specied VLAN.
CONFIGURATION mode or VLAN INTERFACE mode.
fip-snooping enable
By default, FIP snooping is disabled on all VLANs.
3 Congure the FC-MAP value used by FIP snooping on all VLANs.
CONFIGURATION VLAN or INTERFACE mode
fip-snooping fc-map fc-map-value
The default is 0x0EFC00.
The valid values are from 0EFC00 to 0EFCFF.
4 Enter interface conguration mode to congure the port for FIP snooping links.
CONFIGURATION mode
interface port-type slot/port
By default, a port is congured for bridge-to-ENode links.
5 Congure the port for bridge-to-FCF links.
INTERFACE or CONFIGURATION mode
fip-snooping port-mode fcf
NOTE
: To disable the FIP snooping feature or FIP snooping on VLANs, use the no version of a command; for example, no
feature fip-snooping or no fip-snooping enable.
.
Displaying FIP Snooping Information
Use the following show commands to display information on FIP snooping, .
Table 18. Displaying FIP Snooping Information
Command Output
show fip-snooping sessions [interface vlan
vlan-id]
Displays information on FIP-snooped sessions on all VLANs or a
specied VLAN, including the ENode interface and MAC address,
the FCF interface and MAC address, VLAN ID, FCoE MAC address
294 FCoE Transit