Users Guide

show ipv6 ospf neighbor
Display the OSPF neighbor information on a per-interface basis.
Syntax
show ipv6 ospf neighbor [interface]
Parameters
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
•
For a VLAN, enter the keyword vlan then the VLAN ID. The range is 1 to 4094.
Defaults none
Command Modes
EXEC
EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path rst (SPF) calculation.
Syntax
timers spf delay holdtime msec
To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is from 0 to 2147483647. The default is 5
seconds.
holdtime Enter a number as the hold time. The range is from 0 to 2147483647. The default is 10
seconds.
msec Enter the keyword msec to specify the time interval value in milli seconds.
NOTE: If you do not specify the msec option, the timer values are considered as
seconds.
Defaults
• delay = 5 seconds
• holdtime = 10 seconds
994 Open Shortest Path First (OSPFv2 and OSPFv3)