Users Guide

RPF interface: Te 0/4
RPF neighbor: 165.87.31.4
RPF route/mask: 10.10.10.9/255.255.255.255
RPF type: unicast
IPv6 Multicast Commands
The following section contains the IPv6 multicast commands.
debug ipv6 mld_host
Enable the collection of debug information for MLD host transactions.
Syntax
[no] debug ipv6 mld_host [int-count | interface type] [slot/port-range]
To discontinue collection of debug information for the MLD host transactions, use the no debug ipv6
mld_host command.
Parameters
int-count Enter the keyword count to indicate the number of required debug messages.
interface type Enter the following keywords and slot/port information:
• For a 10G Ethernet interface, enter the keyword tengigabitethernet then the
slot/port information.
• For a management interface, enter the keyword managementinterface then the
slot/port information.
•
For a port-channel interface, enter the keywords port-channel then the slot/port
information.
• For a VLAN interface, enter the keyword vlan then the slot/port information.
Default Disabled
Command Modes EXEC
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2.(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To debug the MLD protocol for all ports or for specied ports, use the debug ipv6 mld_host command.
Displayed information includes when a query is received, when a report is sent, when a mcast joins or leaves a
group, and some reasons why an MLD query is rejected.
ip multicast-limit
To limit the number of multicast entries on the system, use this feature.
Syntax
ip multicast-limit limit
Multicast 895