Users Guide

Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ip msdp peer
Congure an MSDP peer.
Syntax
ip msdp peer peer address [connect-source] [description] [sa-limit number]
To remove the MSDP peer, use the no ip msdp peer peer address [connect-source interface]
[description name] [sa-limit number] command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
connect-source
interface
Enter the keywords connect-source then one of the interfaces and slot/port or
number information:
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
•
For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
description name (OPTIONAL) Enter the keyword description then a description name (maximum 80
characters) to designate a description for the MSDP peer.
sa-limit number (OPTIONAL) Enter the maximum number of SA entries in SA-cache. The range is from 1
to 500000. The default it 500000.
Defaults As described in the Parameters section.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The connect-source option is used to supply a source IP address for the TCP connection. When an interface is
specied using the connect-source option, the primary congured address on the interface is used.
Multicast Source Discovery Protocol (MSDP) 869