Users Guide

disable

Enable or disable LLDP.

Syntax

disable

To enable LLDP, use the no disable command.

Defaults Enabled, that is no disable.

Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

9.2(0.0) Introduced on the M I/O Aggregator.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Related Commands

hello

Congure the rate at which the LLDP control packets are sent to its peer.

Syntax

hello seconds

To revert to the default, use the no hello seconds command.

Parameters

seconds Enter the rate, in seconds, at which the control packets are sent to its peer. The rate is

from 5 to 180 seconds. The default is 30 seconds.

Defaults 30 seconds