Users Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show vlan command shown in the following example.
Column Heading Description
(Column 1 — no
heading)
• asterisk symbol (*) = Default VLAN
• G = GVRP VLAN
• P = primary VLAN
• C = community VLAN
• I = isolated VLAN
• O = OpenFlow
NUM Displays existing VLAN IDs.
Status Displays the word Inactive for inactive VLANs and the word Active for active VLANs.
Q
• Displays G for GVRP tagged
• M for member of a VLAN-Stack VLAN
• T for tagged interface
• U for untagged interface
• x (not capitalized x) for Dot1x untagged
• X (capitalized X) for Dot1x tagged
• o (not capitalized o) for OpenFlow untagged
• O (capitalized O) for OpenFlow tagged
• H for VSN tagged
• i (not capitalized i) for Internal untagged
• I (capitalized I) for Internal tagged
• v (not capitalized v) for VLT untagged
• V (capitalized V) for VLT tagged
Ports Displays the type, slot, and port information.
• Po = port channel
• Gi = gigabit Ethernet
• Te = ten-gigabit Ethernet
Example
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P -
Primary, C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
NUM Status Description Q Ports
1 Inactive a
2 Inactive
* 20 Active U Te 0/3,5,13,53-56
Layer 2 839