Users Guide

To remove a network, use the no network ipv6-address [route-map map-name] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of an established route
map.
If the route map is not congured, the default is deny (to drop all routes).
Defaults Not congured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The software resolves the network address congured by the network command with the routes in the main
routing table to ensure that the networks are reachable using non-BGP routes and non-default routes.
Related Commands redistribute — redistributes routes into BGP.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static Enter the keyword static to redistribute manually congured routes. These routes are
treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of an established route
map.
If the route map is not congured, the default is deny (to drop all routes).
Defaults Not congured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
746 IPv6 Border Gateway Protocol (IPv6 BGP)