Users Guide

NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group-name Enter the name of the peer group.
prex-list-name Enter the name of an established prex list. If the prex list is not congured, the default
is permit (to allow all routes).
in Enter the keyword in to distribute only inbound trac.
out Enter the keyword out to distribute only outbound trac.
Defaults Not congured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
neighbor lter-list — assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map — assigns a route map to a neighbor or peer group.
neighbor ebgp-multihop
Attempt and accept BGP connections to external peers on networks that are not directly connected.
Syntax
neighbor {ipv6-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ipv6-address | peer-group-name}
ebgp-multihop [ttl] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group-name Enter the name of the peer group.
ttl (OPTIONAL) Enter the number of hops as the time to live (ttl) value. The range is from 1
to 255. The default is 255.
Defaults Disabled.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
702 IPv6 Border Gateway Protocol (IPv6 BGP)