Users Guide
Command History
Version Description
9.11(0.0) Updated the command output to include the unicast reverse path forwarding (uRPF)
status.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The following describes the show ip interface command shown in the following example.
Lines Description
TenGigabitEthernet
0/0...
Displays the interface’s type, slot/port and physical and line protocol
Internet address... States whether an IP address is assigned to the interface. If one is, that address is
displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the any congured incoming access list. If none is congured, the
phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.
Poison Reverse... States whether poison for RIP is enabled on the interface
ICMP redirects... States if ICMP redirects are sent.
ICMP
unreachables...
States if ICMP unreachable messages are sent.
Example
Dell#show ip interface tengigabitethernet 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
IP unicast RPF check is not supported
Dell#
Usage Information The following describes the show ip interface brief command shown in the following example.
Fields Description
Interface Displays type of interface and the associated slot and port number.
IP-Address Displays the IP address for the interface, if congured.
Ok? Indicates if the hardware is functioning properly.
Method Displays “Manual” if the conguration is read from the saved conguration.
Status States whether the interface is enabled (up) or disabled (administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the interface.
628 IPv4 Routing