Users Guide

Parameters Enabled
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
ip igmp snooping last-member-query-interval
The last member query interval is the maximum response time inserted into Group-Specic queries sent in response to Group-Leave
messages.
Syntax
ip igmp snooping last-member-query-interval milliseconds
To return to the default value, use the no ip igmp snooping last-member-query-interval
command.
Parameters
milliseconds Enter the interval in milliseconds. The range is from 100 to 65535. The default is 1000
milliseconds.
Defaults 1000 milliseconds
Command Modes INTERFACE VLAN
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information This last-member-query-interval is also the interval between successive Group-Specic Query messages. To
change the last-member-query interval, use this command.
ip igmp snooping mrouter
Statically congure a VLAN member port as a multicast router interface.
Syntax
ip igmp snooping mrouter interface interface
To delete a specic multicast router interface, use the no igmp snooping mrouter interface
interface command.
Internet Group Management Protocol (IGMP) 527